Setting The Event - Samsung SRD-470 User Manual

Auto Delete : If you check it, Record Period setup is activated.
~
If you setup the auto delete, recorded data only in the configured period are searchable.
5.
When the recording option setup is done, press <oK>.

SettInG tHe eVent

You can set recording options for sensor, motion, and video loss event.
Sensor Detection
You can set the sensor's operating condition and connected camera, as well as alarm output and its duration.
Using the mouse may help make setup easier.
1. Press the [menu] button on the remote control or front
panel.
2. Use the left/right button (_ +) to select <event>.
Event setting menu is selected.
3. Use the up/down buttons (▲▼) to move to <Sensor
detection>, and press [enTer] button.
A window of sensor detection setup appears.
4. Use direction buttons (▲▼_ +) to move to a desired
item, and set the value.
Sensor Operation : Sets the operation mode of sensors.
~
- <off> : Sensor does not operate.
- <n.o (normal open)> : Sensor is opened.
If the sensor is closed, it generates alarm.
- <n.C (normal Close)> : Sensor is closed.
If the sensor is open by interruption, it generates alarm.
~ Cam : Select a channel to be connected to the sensor.
If selected camera, "Cam preset setup" window appears.
Select a channel and setup the preset.
`
Preset setup can be done in PTZ mode.
Logout
Event
Sensor Detection
Motion Detection
Video Loss Detection
Alarm Schedule
Sensor Detection
Sensor Sensor Operation  Cam  Alarm 
1 OFF  1 None
2 OFF  2 None
3 OFF 3 None

4 OFF 4 None

OK Cancel
Sensor Detection
Cam Preset setup
Sensor Sensor Operation  Cam  Alarm 
1 OFF  1 None
CH  Preset CH 
2 OFF  2 None
1 None  3
3 OFF 3 None

2 None 4

4 OFF  4 None
OK Cancel
OK Cancel
Exit
Duration 
10 sec 
10 sec 
10 sec

10 sec

Duration 
10 sec 
Preset
10 sec 
None 
10 sec

None

10 sec 
English _53