Sustain Settings - Yamaha Electone Stagea ELS-01 Quick Manual

4

Sustain Settings

NOTE
If you change the Voice
when the sustain length is
set to HOLD and the keys
are released, the Voice only
changes after you play
another key.
NOTE
The minimum setting results
in no sustain.
Turning sustain off
automatically resets the
sustain length to be the
default setting.
46 ELS-01/01C/01X Version 1.7 New Functions
Sustain
● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ● ●
The sustain effect, selectable for each Voice, causes Voices to gradually fade out when
the keys are released. The sustain on/off and sustain length settings are independent for
each Voice, providing maximum expressive control.
The Knee Lever can also be used to switch the sustain on/off. Sustain cannot be applied
to the Lead Voices.
To add sustain to the Voices and call up the Sustain
Length Display:
Press one of the SUSTAIN buttons, located to the left of the panel, to
set the sustain. The Sustain Length Display appears.
The lamp of the button lights up to indicate that sustain is on. Press
the button again to turn sustain off and the lamp turns off. When the
lamp is off, sustain does not affect the corresponding keyboard.
Remember to check whether the sustain button lamps are on or off
before you start to play.
Sustain Length Display
To adjust the sustain length value, use the display slider. If you set the highest value
(HOLD), some Voices such as organ or synth will sound continuously even when the
keys are released.
Range: 0 – 12, HOLD
Set the sustain length here.
SUSTAIN
UPPER
(KNEE)
LOWER PEDAL
(KNEE)