Side View Of Lynx - Lynx S-60 User Manual

This is a vinyl cutter. It is not intended to be used with windows drivers or as a printer.
Signwarehouse.com does not recommend that you use these drivers.

1.4 Side View of Lynx

Figure 1-4
1
1. AC Power Connector
2. Fuse
– Up to 3 Amps.
3. Voltage Switch
4. Power Switch
5. Dip Switch label
6. Dip Switch
7. Pen Force Control Slider
8. Universal Serial Bus Connector-
the cutting plotter to a computer through a Universal Serial Bus Cable.
9. Serial Interface Connector (RS-232C)
through a serial interface cable.
10. Parallel Interface Connector (Centronics)
through a parallel interface cable.
1. Learning About Your Cutter
2 3 4
Left Hand Side (Figure 1-4)
– Used to insert the AC power cord.
– The presetting is 230 voltage. Please adjust to comply with your local standard.
– On when switches to [I]; Off when switches to [O]
Right Hand Side (Figure 1-5)
– Indicates the functions of the dip switches.
- Used for various parameter settings.
– Set the blade force here.
Figure 1-5
7
Used in conjunction with Windows Printer Drivers to connect
– Used to connect the cutting plotter to a computer
–Used to connect the cutting plotter to a computer
1-4
8 9 10
5
6