Cutting Test - Lynx S-60 User Manual

2. If the media length is greater than 4 m, leave at least 25 mm margin on the left and right edges of the media
(see Figure 4-15).
Pinch roller

4.13 Cutting Test

In order to achieve the best cutting performance, it is necessary to set cutting conditions that match the cutting
media, giving considerations to the thickness of the sheet and type of material. Lynx can perform a cutting
test to determine the appropriate cutting force and offset value for your media and this can only work under
the off-line condition. Once you fi nish the cutting test, the new origin is also set to the current tool carriage
position.
Procedures:
1. After sizing the media, press the ON/OFF LINE key to change the plotter status to off-line condition.
2. Then use arrow keys to move the tool carriage to the position where you like your test to proceed.
3. Press the CUT TEST key to do the cutting test. The CUT TEST LED turns on.
4. Basic Operation
Note:
The new origin is also set at the cutting test position.
25 mm +
Figure 4-15
4-13
Pinch roller