Quick Menu
1.
Power ON (the POWER LED lights on)
2.
Place the media and pull the lever to lower down the pinch rollers (make sure the pinch rollers are
positioned above the grid drums, that is, within the white marks).
3.
The cutting plotter will size the media automatically according to the setting of the dip switch on
the right side of the cutter (usually the presetting is ROLL media type).
4.
Off-line condition- Plotter is not ready to receive data from computer. Press ON/OFF LINE key, the
LED above is off.
5.
On-line condition- Plotter is ready to receive data from computer. Press ON/OFF LINE , the LED
above lights.
6.
Change the setting value during cutting - Press PAUSE key, the LED above fl ashes. To continue
cutting press ON/OFF LINE .
7.
Terminate the cutting and clear the data in the buffer. - Press ON/OFF LINE or PAUSE and then
press DATA CLEAR .
A. Quick Menu
I