Download Print this page

Operation With The Remote Controller; Automatic Operation (Only For Cool/Dry/Heat Model); Manual Operation - Panasonic CS-KE12NB41 Technical & Service Manual

Dc inverter split system air conditioner
Hide thumbs

Advertisement

Table of Contents

OPERATION WITH THE REMOTE CONTROLLER

1. Automatic Operation
(only for COOL/DRY/HEAT Model)
• Single use
This unit automatically switches between cooling operation and
heating operation according to the difference between the room
temperature and the temperature setting.
• Multiple use
The air conditioner calculates the difference between the
thermostat setting and room temperature, and automatically
determines the mode to operate under cooling or heating. Then,
the air conditioner continuously operates under the mode selected
at initial operation.
Check that the circuit breaker on the power panel is
NOTE
turned on.
Once
mode is selected and the unit is preset by
following the steps below, you can have the air
conditioner automatically bring the room to the desired
temperature simply by pressing the ON/OFF operation
button.
STEP 1
Press the MODE selector button to
STEP 2
Press the ON/OFF operation button.
To stop the air conditioner, press the ON/OFF operation
button again.
To change the temperature setting; press the
NOTE
temperature setting buttons and change the setting to
the desired temperature.

2. Manual Operation

STEP 4
STEP 5
Check that the circuit breaker on the power panel is
NOTE
turned on.
STEP 2
If the automatic operation settings of the unit do not
meet your needs, press the setting buttons as
described below and change the settings as desired.
STEP 1
STEP 1
STEP 2
STEP 3
.
STEP 4
STEP 5
To stop the air conditioner, press the ON/OFF
operation button again.
• Choose the best position in the room for the remote
NOTE
controller, which also acts as the sensor for room
comfort and transmits the operating instructions.
Once you've found this best position, always keep the
remote controller there.
• This appliance has a built-in 5-minute time delay
circuit to ensure reliable operation. When the
operation button is pressed, the compressor will start
running within three minutes. In the event of power
failure, the unit will stop.
• The display on the remote controller shows the setting
temperature and not the room temperature.
• When multiple indoor units are used and units in other
rooms are already operating, they will be operating
with the same mode as the operating indoor units.
(only for "Multiple use" of COOL/DRY/HEAT Model)
Press the MODE selector button
and select the desired mode.
For heating operation
For dehumidifying operation
For cooling operation
For fan only operation
(No Fan mode in "Multiple use" of
COOL/DRY/HEAT Model)
To start the air conditioner, press the ON/
OFF operation button.
Press the TEMP. setting buttons to change
the temperature setting to the desired
temperature.
Adjustable temperature range:
86 °F max.
60 °F min.
Set the FAN SPEED selector button to the
setting you want.
Press the FLAP button and set the airflow
direction as desired.
(Refer to "ADJUSTING THE AIRFLOW
DIRECTION" on page 10.)
STEP 2
STEP 3
STEP 1
7

Advertisement

Table of Contents
loading

  Also See for Panasonic CS-KE12NB41

This manual is also suitable for:

Cu-ke12nk1Cz-18bt1uCs-ke18nb4uwCu-ke18nku