Pride Mobility Quantum 1107 Owner's Manual page 27

V . C O M F O R T
To change the armrest width:
1. Locate the armrest knob on each side of the armrest receiver
bracket. See figure 18.
2. Loosen each knob.
3. Slide the armrests in or out to the desired width.
4. Tighten each knob.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
See figure 18.
2. Loosen the jam nuts.
3. Turn the armrest angle adjusting screw clockwise to lower the
front of the armrest, or counterclockwise to raise the front of
the armrest.
4. Tighten the jam nuts to lock the armrest angle adjusting screw
into place.
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the seat
frame or the power base frame.
To change the controller position:
1. Turn off power to the controller. See VII. "Operation."
2. Disconnect the controller from the power base.
3. Remove the wire ties securing the controller cable to
the armrest.
4. Loosen the setscrew on the underside of both armrests.
See figure 19.
5. Slide the controller out of the armrest.
6. Transfer the controller to the other armrest.
7. Tighten the setscrew on both armrests.
NOTE: If your power chair is equipped with an op-
tional seating system, loosen the mounting screws in
the controller mounting block, transfer the entire as-
sembly to the opposite armrest, and tighten the screws.
See figure 20.
8. Route the controller cable so that it will not be pinched in
the seat hinge.
9. Connect the controller cable to the power base.
10. Secure the controller cable to the armrest with wire ties.
Quantum 1107
A D J U S T M E N T S
SETSCREW
Figure 19. Underside of Armrest
Figure 20. Controller Mounting Block
FOOT
PLATFORM
BRACKET
Figure 21. Foot Platform Adjustment
www.quantumrehab.com
MOUNTING
SCREWS
QUICK RELEASE
FASTENERS
27