Electrical Connection - Ariston Hotpoint Instructions For Use Manual

Installing your appliance
single-phase line
current circuit breaker
Electrical socket
2 pin + earth
to IEC 60083
standard
supply cable
length 1.50 m

ELECTRICAL CONNECTION

The appliance must be fitted correctly to ensure electrical safety.
During fitting and maintenance operations, the appliance must be
unplugged from the electrical system; fuses must be switched off
or removed.
The electrical connections are made before the appliance is
installed in its housing.
Ensure that:
- the electrical installation has sufficient power,
- the electrical wires are in good condition,
- the diameter of the conductors complies with the requirements
of the installation.
Your oven must be connected with a (standardised) power cable
with three conductors of 1 mm² (1ph + 1N + earth) which must be
connected to a 220-240V ~ single-phase supply via a
1ph + 1 neutral + earth IEC 60083 standardised power socket or
via an all-pole cut-off device in compliance with installation rules.
220-240 V ~
10A fuse or residual
Power
approx.
Single-phase 20A Meter
220-240V ~ 50 Hz
Note
The safety wire (green-yellow) is connected to the
appliance's terminal and must be connected to
the electrical installation's earth system.
Where connected to a wall socket, the socket must
remain accessible after installation.
The circuit should be protected with a 10 Amp fuse.
If the power cable is damaged, it must be replaced by
the manufacturer, its After-Sales Service Department
or a similarly qualified person to prevent danger.
EN
3