Installation Codes And Standards; Assembly - Vulcan-Hart GHF90 Installation & Operation Manual

The installation location must allow adequate clearances for servicing and proper operation.
A minimum front clearance of 36" (91 cm) is required.
Do not obstruct the flow of combustion and ventilation air. Adequate clearance for air openings into the
combustion chamber must be provided. Make sure there is an adequate supply of air in the room to
replace air taken out by the ventilating system. This will prevent fryer function from being affected by
a reduced atmospheric pressure.
Do not permit fans to blow directly at the fryer. Wherever possible, avoid open windows next to the
sides or back of the fryer. Avoid wall-type fans which create air cross currents within the room.

INSTALLATION CODES AND STANDARDS

Your Vulcan fryer must be installed in accordance with:
In the United States of America:
1. State and local codes.
2. National Fuel Gas Code, ANSI-Z223.1 (latest edition). Copies may be obtained from The American
Gas Association, Inc., 1515 Wilson Blvd., Arlington, VA 22209.
3. National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The
National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
In Canada:
1. Local codes.
2. CAN/CGA-B149.1 Natural Gas Installation Code (latest edition). (Copies may be obtained from The
Canadian Standard Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3.)
3. Canadian Electrical Code, CSA C22.2 No. 3 (latest edition). Copies may be obtained from The
Canadian Standard Association, 178 Rexdale Blvd., Etobicoke, Ontario, Canada M9W 1R3.

ASSEMBLY

Fasten backsplash at rear of fryer. Place crumb tray in the fry tank. Hook fry baskets onto the
backsplash.
Legs/Casters
Toe bases or legs ordered with GHF Series Fryers will be attached to the fryer.
NOTICE: When the fryer is mounted on casters, it must be installed with the casters supplied, a
connector (not supplied by Vulcan) complying with either ANSI Z21.69 (latest edition) or CAN/CGA-
6.16 (latest edition), and a quick-disconnect device complying with either ANSI Z21.41 (latest edition)
or CAN1-6.9 (latest edition). It must also be installed with restraining means to guard against
transmission of strain to the connector, as specified in the appliance manufacturer's instructions.
– 5 –