Troubleshooting And Error Messages - Sansui WLD+201L User Manual

16. Troubleshooting and error messages

The WLD+201 is equipped with state-of-the-art technology and is safe to operate. Nevertheless, problems or malfunctions
may occur. Before contacting Sansui customer support, refer to the following for possible solutions.
PROBLEM
No power when switched on
No sound
No sound in one channel
Loud buzz or hum
Weak bass, diffused stereo image
Distorted sound
Audio input source switches not
working
Remote control not working
Interference during reception
POSSIBLE SOLUTION
- Mains socket not switched on or faulty
Plug not fully inserted into wall socket
-
Internal mains fuse has blown inside the unit,
-
this will need to be replaced by a qualified service
technician
Power cord has become damaged, this should be
-
replaced immediately by a qualified technician
- Power not turned on
Volume setting low
-
Loudspeaker cables not connected
-
No input audio equipment is connected or is faulty
-
Correct audio input source not selected on front panel
-
- Audio source input cables connected incorrectly or
damaged
Audio input source faulty
-
Loudspeaker cables connected incorrectly or
damaged
Loudspeakers are faulty
-
Audio input cables damaged or not correctly
-
connected
Turntable earth lead incorrectly fitted
-
Turntable head shell incorrectly fitted.
-
CD player sited too close to TV
-
Speaker connections out of phase check + and – terminals
-
are connected to corresponding terminals on both
amplifier and loudspeakers
Frayed wires may be touching on speaker terminals
-
causing distortion
- Bass and treble controls may be too high for
loudspeaker specification.
Volume control may be set too high
-
Internal fault would need servicing by a qualified service
-
technician.
Check if the batteries have been inserted correctly.
-
If batteries are empty, replace them with new ones.
-
Point the remote control at the remote sensor and press to
-
operate.
Remove any objects found between the remote control
-
and the remote sensor.
- Make sure the distance between the remote control and
the device does not exceed 8 m
The reception frequency has not been set properly.
-
The antenna has not been positioned properly.
-
Start a station search.
-
Page | 42
© Sansui UK 2012 WLD+201 IB Ver 1.0 Rev 0.0