Using The Flasutil Bios Update Utility Menu (From The Support Cd) - IBM TotalStorage FAStT FC2-133 Installation And User Manual

v To update BIOS NVRAM defaults, type:
v To verify NVRAM in all adapters, type:

Using the flasutil BIOS Update Utility menu (from the Support CD)

Complete the following steps to update the FAStT FC2-133 Adapter BIOS code
using the flasutil BIOS Update Utility menu:
10. Go to "Installing the FAStT FC2-133 Adapter device drivers" on page 16.
Press Enter.
Press Enter.
Press Enter.
1. Insert the IBM TotalStorage FAStT FC2-133 Host Bus Adapter Support CD into
the CD-ROM drive. Restart the server. Your server starts to a DOS prompt.
2. From the DOS prompt, type:
3. Press Enter.
4. If you have only one adapter installed, go to step 5. If you have more than one
adapter installed, a list of adapters and I/O addresses displays. At the
command prompt, type the appropriate I/O address and press Enter.
5. The following option menu displays.
Notes:
a. All of the listed options are supported and you can run them from the
command line. Options L, A, D, U, and X might not display.
b. Each adapter can be configured with more than one option.
6. Type the letter for the option you want and press Enter.
7. If you have additional adapters installed or if you want to configure your
adapter with more than one option, continue with step 8. Otherwise, go to step
9.
8. Repeat steps 2 through 6 for each additional adapter or if you want to
configure your adapter with more than one option.
9. Remove the CD from the CD-ROM drive and restart the server.
Chapter 2. Updating the FAStT FC2-133 Adapter BIOS code and installing device drivers
11