Table of Contents
Advertisement
9. Connect one end of an LC-LC Fibre Channel cable to the optical interface
connector on the FAStT FC2-133 Adapter. Connect the other end to a Fibre
Channel device.
10. Carefully install and secure the server cover.
11. Connect the power cables.
12. Turn on all external Fibre Channel devices; then, turn on the server. The
following information is displayed:
To display the Fibre Channel devices, press Ctrl+Q, and then use the Fast!UTIL
program. See Chapter 3, "Using IBM Fast!UTIL" on page 17 for detailed utility
program information.
If the information displayed is not correct and you have checked the adapter
configuration, go to Chapter 5, "Troubleshooting" on page 25 for problem solving
information.
If the information displayed is correct, go to Chapter 2, "Updating the FAStT
FC2-133 Adapter BIOS code and installing device drivers" on page 9 for detailed
instructions on how to update the FAStT FC2-133 Adapter BIOS code.
Chapter 1. Preparing and installing the IBM TotalStorage FAStT FC2-133 Host Bus Adapter
7
Advertisement
Table of Contents
