Data And Power Connector; Table 3. J1 Connector Pinouts - Planar EL640.480-AG1 Series User Manual

Data and Power Connector

The EL640.480-AG1 display uses the Samtec STMM-110-01-T-D and the
EL640.480-AG1 ET display uses the Samtec EHT-110-01-S-D or equivalent locking
connectors. Although these connectors differ slightly, their pinouts are identical
and are shown in the table below. The mating connector for both displays is in
the Samtec TCSD family of cable strips. The proper connector, user-specified
cable length, and connector configuration are supplied as a single unit. A low-
profile version display, the EL640.480-AG1 LP, uses the EHT110-01-S-D-RA right-
angle connector. Consult your Samtec representative (1-800-SAMTEC9) for the
cable/connector options.

Table 3. J1 Connector Pinouts.

Pin Signal
1
3
5
7
9
11
13
15
17
19
(Viewed from back of display)
Description
UD1 Video data (upper)
UD3 Video data (upper)
LD1 Video data (lower)
LD3 Video data (lower)
CP2 Data input clock
CP1 Input data latch.
S Scan start-up signal
GND Ground
V +5 V Power
L
V +12 V Power
H
EL640.480 AG1 Series User's Manual (020-0350-00B)
Pin 1 Pin 2
Samtec STMM-110-01-T-D
Pin Signal Description
2 UD0 Video data (upper)
4 UD2 Video data (upper)
6 LD0 Video data (lower)
8 LD2 Video data (lower)
10 GND Ground
12 GND Ground
14 GND Ground
16 GND Ground
18 V +5 V Power
L
20 V +12 V Power
H
Key
7