Replacing The Inverter - Lenovo 5106 Maintenance Manual

1. Reconnect all the rear I/O assembly cables. See "Locating parts on the system board" on page 71.
2. Position the new rear I/O assembly into the slots, and route the rear I/O assembly cables so that the
excess cables tuck in the rear I/O assembly, and then push the rear I/O assembly
rear I/O assembly-locking tabs
3. Install the two screws
4. Reinstall the rear I/O shielding. See "Installing the rear I/O shielding" on page 78.
5. Go to "Completing the FRU installation" on page 109.

Replacing the inverter

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important Safety
Information" on page 1.
This section provides instructions on how to replace the inverter.
2
snap into position.
1 that secure the rear I/O assembly to the main bracket.
1 downward until the
.
Chapter 9 Replacing FRUs
97