Fujitsu PRIMERGY BX620 S6 Options Manual page 20

Safety instructions
Transport the device only in the original packaging or in packaging
that protects it from knocks and jolts.
Installation and operation
V
CAUTION!
Read the notes on installation and operation in the operating manual
of the BX600 S3 basic unit.
When installing the server blade in the basic unit, beware of the
energy hazard at the midplane contacts. A short-circuit on these
contacts may damage the system.
Data cables must be adequately shielded to avoid interference.
For the LAN wiring, the requirements according to standards EN
50173 and EN 50174-1/2 apply. The minimum requirement is the use
of a protected LAN line of category 5 for 10/100 Mbit/s Ethernet,
and/or of category 5e for Gigabit Ethernet. The requirements of the
specification ISO/IEC 11801 must also be taken into account.
Route the cables in such a way that they do not form a potential
hazard (tripping) and cannot be damaged. When connecting the
device, refer to the relevant notes in the operating manual.
Do not connect or disconnect any data transmission cables during a
thunderstorm (lightning hazard).
Make sure that no objects (such as bracelets or paper clips) or liquids
get inside the device (risk of electric shock or short circuit).
In emergencies (e.g. damaged casing, control elements or cables,
penetration of liquids or foreign bodies), switch off the device
immediately, unplug it from the grounded power outlets, and contact
your customer service center.
Proper operation of the device (in accordance with IEC60950/EN
60950) is only ensured if the casing is completely assembled and the
rear covers for the installation openings are in place (electric shock,
cooling, fire protection, interference suppression).
20 Options Guide
BX620 S6