Removing The Retainers - Roland Modela MDX-40 User Manual

2-2 Installation

Removing the Retainers

Retainers are attached to the machine to protect it from vibration during transportation. When installation is complete,
remove these.
CAUTION
Remove all retainers. Any that remain may cause faulty operation or breakdown when the power is switched
on.
Store these retainers carefully, because they are needed again when transporting the machine for relocation or
the like.
Remove the screws shown in the figure, then detach these retainers.
Mount the screws at its original location on the machine.
24 Chapter 2 Preparation
Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
Hexagonal wrench
Retainer
Hexagonal wrench
Retainer