How To Use Your Heater - DeLonghi electric oil filled radiator Important Instructions Manual

FITTING THE WHEELS
Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint
finish.
Fully unfold the castors by turning them outwards (Fig. 1).
Turn the radiator back to its upright position.
BE CAREFUL
Operate the heater in upright position only (wheels on the bottom, controls on the top). Any other
position could create hazard situation!
ON/OFF Switches
Pilot lights
800
700
WATTS
WATTS
BOTH 1500 WATTS
With pilot lights ON, the heater is ON!
1. LOCATION
Place heater on floor beneath coldest window in the room or any desired location. Your heater will
minimize the effect of cold drafts.
The heater must not be located immediately below a socket-outlet.
Do not use this radiator in rooms having a surface area less than 4 m
2. CONNECTION
The radiator must be connected to a properly polarized A/C 115/220 V (check the voltage on the
label positioned on the cable) household outlet in perfect working conditions.
Keep loose clothing or bedding, furniture and flammable material away from the wall outlet where
the heater plug is fitted in.
3. SWITCHING ON TWO-SWITCHES MODELS
Turn thermostat clockwise to the maximum position. Switch on both switches. The lights on the swit-
ches remain on indipendent of the cycling of the thermostat. When room reaches desired tempera-
ture, turn the thermostat knob counter clockwise very slowly and carefully until you hear a "click".
This will automatically set your unit to cycle on and off at that desired heat setting. (For timer
instructions, see point 5).
Note: It will normally require approx.15 minutes to reach operating temperature.

HOW TO USE YOUR HEATER

WATTS ECONOMIZER
For more economical use, the Min. or Med. Watt switches may be used
individually, after unit has reached the operating temperature.
.
2
3