Graco 310645H Repair And Parts Manual page 28

Problem
Material runs out of bottom of sprayer RotoFlex HD Pump worn out
No air from compressor
Speed of application too slow
Speed of application too slow (cont.) Flow control set too low
Intermittent flow/sputtering or air in
material
Air quick disconnect does not stay
connected.
Gun will not shut off
Fluid leaking at Flow Adjustment Nut Damaged seal.
Needle adjustment won't adjust
28
Cause
Loose fittings
Gun air valve closed
Gun needle plugged
Lines not connected
Damaged hose
Worn compressor
Material too thick
Nozzle too small
Plugged or dirty gun
Kinked hose
Gun fluid flow adjustment set too low Increase flow adjustment with flow
Hopper connection not tight
Debris in system
Dirty or corroded fitting
Worn nozzle or needle.
Debris in needle passage
Dirty threads
Nozzle not on gun
Flow nut set to maximum adjustment Turn flow nut adjustment the other
Troubleshooting
Solution
Replace hose.
Check and retighten all fittings.
Open gun air valve.
Clean needle and retry.
Check all quick disconnect connec-
tions to gun and hoses.
Replace hose.
Service compressor. Contact a quali-
fied Graco Service Center.
Thin material.
Change nozzles to a larger size. See
Operation Manual, Recommended
Nozzle Selection Chart, page 20.
Increase flow control setting
Relieve Pressure, page 7. Clean
gun.
Unkink hose.
adjustment nut.
Check gasket. TIghten connection.
Clean
Clean thoroughly. Soak in oil. Apply a
few drops of light oil.
Relieve Pressure, page 7. Replace
worn parts.
Relieve Pressure, page 7. Clean.
Relieve Pressure, page 7. Replace
seal.
Clean threads
Put nozzle on gun
way
310645H