Installation; Operation - DeLonghi Fan heater Instruction Manual

GB
ELECTRICAL CONNECTION
- Before using the appliance check that your supply voltage is the same of that shown on
the rating label of the unit.
- THIS APPLIANCE CONFORMS TO DIRECTIVE 89/336/CEE GOVERNING RADIO
INTERFERENCE.

INSTALLATION

The appliance can be used on any horizontal support surface.
The models without adjustable base can be wall-mounted, using 3 screws and 3 wall plugs.
To mount the appliance on the wall, proceed as follows:
- drill the first hole in the wall, heeding the minimum distances indicated in Fig. 1;
- hang the appliance on the wall and mark the place where the other 2 holes are to be dril-
led in the wall, in order to fasten the appliance safely;
- installations in bathrooms must be performed by qualified persons, in compliance with the
standards in force;
The appliance must be installed outside of the prescribed protective volume (Fig. 2) and in
any case away from bathtubs, showers, washbasins, taps, etc.
The appliance must not be positioned directly underneath a fixed power
point.

OPERATION

- Summer use: (ventilation only): turn the thermostat dial fully clockwise to the maximum
position
- Reduced power operation (only on some models): turn the thermostat dial to the
maximum position and press the "o" switch (the pilot light will turn on).
- Full power operation (only on some models): turn the thermostat dial to the maximum
position and press the "o" and "oo" switches (the pilot lights will turn on).
- Setting the thermostat:
When the room has reached the desired temperature, turn the thermostat knob slowly in
an anti-clockwise direction until you get to the setting — and not beyond it — where you
hear a click (or, for models with warning lights, until those lights turn off). The thermostat
will then adjust that set temperature automatically and keep it constant.
If your appliance is the type with 2 switches, you could utilize only one of them during
mild seasons and on days not particularly cold. You will thus use but little electrical power
and obtain even greater savings in energy consumption.
- Anti-freeze function
With the thermostat in the
keep the room at a temperature of approximately 5°C, thereby preventing freezing,
at a minimum consumption of energy.
- Switching the appliance off: turn off the switches and turn the thermostat dial anti-
clockwise to the minimum position
MODELS WITH 24 HOUR TIMER
To set the heating periods proceed in the following manner:
- Check the time by your watch. Supposing it is 10.00 a.m. turn the numbered dial of the
time-clock in a clockwise direction until the number 10 coincides with the reference mark
on the time-clock. Set the time period during which you wish the appliance to work by
pushing the black notches towards the centre. Each notch corresponds to a period of 15
minutes. At this point red sections will be visible corresponding to the working periods.
Set in this way the radiator will function automatically every day during the set period.
(Important: the plug must always remain connected to power supply).
- To change the programmed time period, just bring back the black notches to their original
position and set the new working periods required.
4
position and the switches pressed, the appliance will
.