Brother DCP-J140W Quick Start Manual page 12

For Wireless Network Users
Configuration using the
12
CD-ROM installer and a
USB cable (Windows
only)
a
Put the supplied installation CD-ROM into your
CD-ROM drive. Follow the on-screen
instructions.
b
The CD-ROM Top Menu will appear. Click
Install MFL-Pro Suite and click Yes if you
accept the license agreements. Follow the
on-screen instructions.
c
Choose Wireless Network Connection, and
then click Next.
d
When Firewall/AntiVirus detected screen
appears, choose Change the Firewall port
settings to enable network connection and
continue with the installation.
(Recommended) and click Next.
If you are using a firewall other than the
®
Windows Firewall see the instructions
provided with your firewall software for
information on how to add the following
network ports.
 For network scanning, add UDP port 54925.
 If you still have trouble with your network
connection, add UDP port 137 and 161.
e
Choose Yes, I have a USB cable to use for
installation. and then click Next.
Note
If the Important Notice appears, check the box
after you confirm the SSID and Network Key, and
then click Next.
f
Temporarily connect the USB cable (not
included) directly to the computer and the
machine.
If the confirmation screen appears, check the
box and click Next, go to g.
Otherwise, go to h.
12
g
When the following screen appears, check Yes
if you want to connect to the listed SSID. Click
Next and go to j.
®
h
When the following screen appears, the wizard
will search for wireless networks available to
your machine. Choose the SSID that you wrote
down for your network in step 11-a on
page 10, and then click Next.
Note
• If the list is blank, check that the access point
has power and is broadcasting the SSID, and
then see if the machine and the access point
are within range for wireless communication.
Then click Refresh.
• If your access point is set to not broadcast the
SSID you can manually add it by clicking the
Advanced button. Follow the on-screen
instructions for entering the Name (SSID), and
then click Next.
i
Enter the Network Key you wrote down in
step 11-a on page 10 and then click Next.
Note
If your network is not configured for
Authentication and Encryption, the following
screen will appear. To continue configuration,
click OK and go to j.