Use The Diagnostic Tools On The Wireless Controller - NETGEAR ProSafe WC7520 Reference Manual

Use the Diagnostic Tools on the Wireless Controller

As part of the diagnostics functions on the wireless controller, you can ping a managed
access point from the wireless controller or trace its route from the wireless controller.

To ping an access point:
1. Select Diagnostics > Ping. The Ping screen displays.
Figure 112.
2. In the Ping Count field, enter the number of ping packets to be sent. (The default number is
10.)
3. From the Access Point drop-down list, select the access point to be pinged. After you have
made your selection, the IP address of the access point displays in the IP Address field.
4. Click Start. The results are shown in the Ping Result field.

To trace a route to an access point:
1. Select Diagnostics > Trace Route. The Trace Route screen displays (see the following
figure).
2. From the Access Point drop-down list, select the access point for which you want to trace
the route. After you have made your selection, the IP address of the access point displays in
the IP Address field.
3. Click Start. The results are shown in the TraceRoute Result field.
ProSafe 20-AP Wireless Controller WC7520
Troubleshooting
184