Netgear Prosafe Access Points - NETGEAR ProSafe WC7520 Reference Manual

NETGEAR ProSafe Access Points

You can connect access points to the wireless controller either directly with an Ethernet cable
through a router or switch, or remotely through an IP network. After you have used the
automatic discovery process and added access points to the managed access point list on
the wireless controller, the wireless controller converts the standard access points to
dependent access points by pushing firmware to the access points. From then on, you can
centrally manage and monitor the access points.
A WC7520 wireless controller system can support the following access points:
• WNAP210 ProSafe Wireless-N Access Point
- Supports 802.11b, 802.11g, and 802.11n network devices
- Supports Power over Ethernet (PoE) with a power consumption of up to 5.8W
For product documentation, see
http://support.netgear.com/app/products/model/a_id/8101.
• WNAP320 ProSafe Wireless-N Access Point
- Supports 802.11b, 802.11g, and 802.11n network devices
- Supports Power over Ethernet (PoE) with a power consumption of up to 5.8W
- Accepts optional antennas
For product documentation, see
http://support.netgear.com/app/products/model/a_id/18601.
• WNDAP350 ProSafe Dual Band Wireless-N Access Point
- Supports 802.11a, 802.11b, 802.11g, and 802.11n network devices
- Supports PoE with a power consumption of up to 10.75W
- Concurrent operation in 2.4 GHz and 5 GHz radio band while in 802.11n mode
- Accepts optional antennas
For product documentation, see
http://support.netgear.com/app/products/model/a_id/12823.
• WNDAP360 ProSafe Dual Band Wireless-N Access Point
- Supports 802.11a, 802.11b, 802.11g, and 802.11n network devices
- Supports PoE with a power consumption of up to 10.51W
- Concurrent operation in 2.4 GHz and 5 GHz radio band while in 802.11n mode
- Accepts optional antennas
For product documentation, see
http://support.netgear.com/app/products/model/a_id/19189.
ProSafe 20-AP Wireless Controller WC7520
Introduction and Overview
15