NETGEAR ProSafe WC7520 Reference Manual page 77

Table 16. Network authentication and data encryption settings (continued)
Network authentication
selection
Shared Key
Legacy 802.1x
WPA with Radius
ProSafe 20-AP Wireless Controller WC7520
Data encryption Configuration steps
options
64-bit WEP To configure Shared Key authentication with WEP:
128-bit WEP
1. From the Data Encryption drop-down list, select a level of
152-bit WEP WEP encryption:
- 64-bit WEP. Uses 40/64-bit encryption.
- 128-bit WEP. Uses 104/128-bit encryption.
- 152-bit WEP. A proprietary mode that works only with other
wireless devices that support this mode.
2. Select a key radio button (Key1, Key2, Key3, or Key4).
3. Enter a key in the corresponding field:
- 64-bit WEP requires a key with 10 characters.
- 128-bit WEP requires a key with 26 characters.
- 152-bit WEP requires a key with 32 characters.
None To configure legacy 802.1x authentication:
1. Set up and enable an internal or external (RADIUS or LDAP)
authentication server. For information, see
Authentication Servers and Authentication Server Groups
page 115.
2. Select the Local or External radio button.
3. If you select the External radio button, select the
authentication server that you wish to use from the
drop-down list.
TKIP To configure WPA authentication with a RADIUS server:
TKIP + AES
1. Set up and enable an internal or external (RADIUS or LDAP)
authentication server. For information, see
Authentication Servers and Authentication Server Groups
page 115.
2. From the Data Encryption drop-down list, select the type of
encryption:
- TKIP. Supports Temporal Key Integrity Protocol (TKIP) only.
- TKIP + AES. Supports both TKIP and Advanced
Encryption Standard (AES).
3. Select the Local or External radio button.
4. If you select the External radio button, select the
authentication server that you wish to use from the
drop-down list.
Managing Security Profiles and Profile Groups
77
Manage
on
Manage
on