Customer Information - NetComm NP560 Installation Manual

Customer Information

ACA (Australian Communications Authority) requires you to be aware of the following information and warnings:
(1) This unit shall be connected to the Tel ecommu ni cation Network through a line cord which meets the require-
ments of the ACA TS008 Standard.
(2) This equipment has been tested and found to comply with the Standards for C-Tick and or A-Tick as set by
the ACA. These standards are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio noise and, if not installed
and used in accordance with the instructions detailed within this manual, may cause interference to radio
communications. However, there is no guarantee that interference will not occur with the installation of this
product in your home or office. If this equipment does cause some degree of interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, we encourage the user to try
to correct the interference by one or more of the following measures:
• Change the direction or relocate the receiving antenna.
• Increase the separation between this equipment and the receiver.
• Connect the equipment to an alternate power outlet on a different power circuit from that to which the
receiver/TV is connected.
• Consult an experienced radio/TV technician for help.
(3) The power supply that is provided with this unit is only intended for use with this product. Do not use this
power supply with any other product or do not use any other power supply that is not approved for use with
this product by NetComm. Failure to do so may cause damage to this product, fire or result in personal injury.
10 NP560-NP562 Installation Guide
YML821 Rev1