Digital Dubbing Of Recorded Images/Sounds Between Tapes - JVC GR-DVX7 Instructions Manual

Power Switch
Open the
connector cover.
DV cable
(optional)
Video unit equipped
with DV connector
RM-V713U
(provided)
T W
PLAY (4)
STOP (5)
Digital Dubbing Of Recorded Images/
Sounds Between Tapes
It is also possible to copy recorded scenes from the
camcorder onto other video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
1
2
Lock Button
3
4
To DV OUT
NOTES:
To DV IN
CONFIRM POWER-OFF STATUS
Make sure the camcorder's power is off.
MAKE CONNECTIONS
Connect the camcorder to your video unit equipped
with a DV connector using the DV cable (optional) as
shown in the illustration.
START PLAYBACK
Press 4 to play back the source tape.
START RECORDING
While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery pack
( pg. 9).
When using the camcorder for dubbing, be sure to use it
as a player. The camcorder's DV connector is only for
output.
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If the
above occurs, turn off power and make connections
again.
If "Playback Zoom" (
Effects" ( pg. 83), "Superimposing A Title/Frame"
( pg. 69) or "Snapshot" is attempted during playback,
only the original playback image recorded on the tape is
output from the DV OUT connector.
Be sure to use a DV cable with the core filter.
EN
pg. 82), "Playback Special
75