Holding This Unit; Tripod Mounting; Using The Remote Control - JVC GZ-GX3 Detailed User Manual

Holding this Unit

When holding this unit, keep your elbows close to your sides to prevent
camera shake.
.
Hold the LCD monitor with your left hand and adjust the angle accordingly.
0
Holding the LCD monitor with your left hand helps to stabilize the camera
for recording.
Caution :
Be careful not to drop this unit during transportation.
0
Guardians should pay close attention when this unit is being used by
0
children.
Memo :
If camera shake is excessive, use the image stabilizer.
0
"Reducing Camera Shake" (A p. 111)

Tripod Mounting

This unit can be mounted on a tripod (or monopod). This is useful for
preventing camera shake and recording from the same position.
.
To prevent this unit from falling off, check the tripod mounting screw holes
0
and positioning holes on the unit carefully before mounting, and turn the
screws until they are fastened firmly.
Caution :
To prevent injuries or damages which may result if this unit falls off, read
0
the instruction manual of the tripod (or monopod) to be used and make
sure that it is securely attached.
Memo :
It is recommended to use a tripod or monopod when recording in
0
conditions prone to camera shake (such as in dark places or when zoomed
to the telephoto end).
Set the image stabilizer to b (OFF) when using a tripod for recording.
0
"Reducing Camera Shake" (A p. 111)

Using the Remote Control

You can operate this unit from a distance away using the supplied remote
control.
Remote Sensor
.
Memo :
Point the remote control toward the sensor directly and use it within 5 m
0
from this unit.
The transmitted beam may not be effective or may cause incorrect
0
operation when the sensor is directly exposed to sunlight or powerful
lighting.
Preparing the Remote Control
.
Using the Remote Control for the First Time
.
A button battery (CR2025) is included inside the remote control at the time
0
of purchase.
Remove the insulation sheet before use.
Reinserting the Battery
Lock Tab
.
Pull out the battery holder by pressing the lock tab.
0
Insert the button battery with the + side facing upward.
0
Getting Started
CR2025
Pull out the insulation sheet
Button Battery
71