Ravenheat CSI 85T Installation And Servicing Instructions page 53

Electronic ignition - automatic modulating boiler condensing fanned combi
Table of Contents

Advertisement

The code of practice for the installation, commissioning & servicing of gas central heating
Installation, Commissioning and Service Record Log Book
NAME
ADRESS
1. Please keep the Log Book in a safe place for future reference.
2. This Log Book is to be completed in full by the competent person(s) who commissioned the boiler and associated equipment and then handed to
the customer. When this is done, the Log Book is a commissioning certificate that can be accepted as evidence of compliance with the appropriate
Building Regulations.
3. Failure to install and commission this appliance to the manufacturer's instructions may invalidate the warranty.The above does not affect your statutory rights.
INSTALLER & COMMISSIONING ENGINEER DETAILS
COMPANY NAME
ADRESS
INSTALLER'S NAME
CORGI REGISTRATION DETAILS
NAME
ADRESS
CORGI REGISTRATION DETAILS
APPLIANCE & CONTROL DETAILS
BOILER
MAKE AND MODEL
APPLIANCE SERIAL No.
LOCATION
CONTROLS
To comply with the Building Regulations, each section must have a tick in one or other of the boxes.
REQUIREMENT
1. TIME AND TEMPERATURE CONTROL TO HEATING
2. TIME AND TEMPERATURE CONTROL TO HEATING
3. HEATING ZONE VALVES
4. THERMOSTATIC RADIATOR VALVES
5. AUTOMATIC BYPASS TO SYSTEM
6. BOILERI INTERLOCK
PLEASE FOLLOW THE INSTALLATION AND COMMISSIONING INSTRUCTIONS IN THE INSTALLATION MANUAL SUPPLIED WITH THE EQUIPMENT
COMISSIONING PROCEDURE INFORMATION
FOR ALL BOILERS
HAS THE SYSTEM BEEN FLUSHED IN ACCORDANCE
WITH THE BOILER MANUFACTURER'S INSTRUCTIONS?
WHAT WAS THE CLEANSER USED?
WHICH INHIBITOR WAS USED?
For the central heating mode, measure and record:
HEAT INPUT
BURNER OPERATING PRESSURE
CENTRAL HEATING FLOW TEMPERATURE
CENTRAL HEATING RETURN TEMPERATURE
FOR COMBINATION BOILERS ONLY
HAS A WATER SCALE REDUCER BEEN FITTED?
WHAT TYPE OF SCALE REDUCER HAS BEEN FITTED?
The content of this Log Book has been produced in
consultation with
CUSTOMER DETAILS
IMPORTANT
INSTALLER DETAILS
COMMISSIONING ENGINEER
I ROOM STAT & PROGRAMMER/TIMER
CYLINDER STAT & PROGRAMMER/TIMER
FITTED
FITTED
FITTED
PROVIDED
YES
NO
©
CENTRAL HEATING INFORMATION COUNCIL
TEL No.
INSTALLER DATE
TEL No.
REG No.
CORGI ID SERIAL No.
(IF DIFFERENT)
COMMISSIONING DATE
TEL No.
REG No.
CORGI ID SERIAL No.
NEW SISTEM
MEASURES PROVIDED
PROGRAMMABLE ROOMSTAT
COMBI BOILER
NOT REQUIRED
NOT REQUIRED
HAS AN INHIBITOR BEEN USED?
Benchmark is supported by
SEDBUK No.
%
%
OR REPLACEMENT BOILER
YES
NO
kW
mbar
°C
°C
YES
NO

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents