Download Print this page

Risk Of Fire; Pre-Installation - Frigidaire FFLG2022MW0 Installation Manual

Laundry center
Hide thumbs


Table of Contents
For your safety the information
in this manual must be followed to minimize the risk of fire or explosion or to prevent
property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
Read all of the following
before installing
and using this appliance:
- Destroy the carton and plastic bags after the laundry center is unpacked. Children might use them for play. Cartons
covered with rugs, bedspreads, or plastic sheets can become airtight chambers causing suffocation. Place all mate-
rials in a garbage container or make materials inaccessible to children.
- Clothes dryer installation and service must be performed by a qualified installer, service agency or the gas supplier.
- Install the appliance according to the manufacturer's
instructions and local codes.
- The electrical service to the appliance must conform with local codes and ordinances and the latest edition of the
National Electrical Code, ANSI/NFPA 70, or in Canada, the Canadian electrical code C22.1 part 1.
- The gas service to the dryer must conform with local codes and ordinances and the latest edition of the National
Fuel Gas Code ANSI Z223.1, or in Canada, CAN/ACG B149.1-2000. An individual manual shut-off valve must be
installed within 6 ft (1.83 m) of the dryer in accordance with the National Fuel Gas Code, ANSI Z223.1/NFPA 54.
- The laundry center is designed under ANSI Z 21.5.1 or ANSI/UL 2158 - CAN/CSA C22.2 No. 112 (latest editions) for
HOME USE only. This dryer is not recommended for commercial applications such as restaurants, beauty salons, etc.
- Do not install a clothes dryer with flexible plastic or flexible foil venting material. Flexible venting materials are
known to collapse, be easily crushed and trap lint. These conditions will obstruct clothes dryer airflow and increase
the risk of fire.
- The instructions in this manual and all other literature included with this appliance are not meant to cover every
possible condition and situation that may occur. Good safe practice and caution MUST be applied when installing,
operating and maintaining any appliance.
- Do not try to light any appliance.
- Do not touch any electrical switch; do not use any phone in
your building.
- Clear the room, building or area of all occupants.
- Immediately
call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
- If you cannot reach your gas supplier, call the fire department.
To avoid back or other injury, have more than
one person move or lift the appliance.
Save these instructions for
futu re reference,
Tools and materials needed for installation:
- Adjustable pliers
- Phillips, straight, & square bit
screwd rivers
- Adjustable wrench
- Pipe wrench for gas supply (gas
- LP-resistant thread tape (for natu-
ral gas or LP supply, gas dryer)
- Carpenter's level
- External vent hood
- 4-inch (102 mm), rigid metal or
semi-rigid metal exhaust duct work
- 3-wire or 4-wire 240 volt cord kit
(electric dryer)
- 4 in. (10.2 cm) clamp
- Gas line shutoff valve (gas dryer)
- 1/2NPT union flare adapters (x2)
and flexible gas supply line (gas
- Metal foil tape (not duct tape)


Table of Contents

  Also See for Frigidaire FFLG2022MW0

  Related Manuals for Frigidaire FFLG2022MW0

This manual is also suitable for: