Table of Contents
Advertisement
Installation of Custom Door Panels
This description concerns the model on which a decorative
door is installed.
① Loosen the anchor screws on the lower hinge of the door and
separate the door.
② Arrange the decorative door so that it matches the door of the
product.
①
③ Mark the center point of the top hinge and lower hinge holes that
extend over the overlay panel. Then drill 3/8" diameter holes
1/4" deep at that point.
④ Remove the overlay panel from the door and tighten the two M4×8
truss head screws, securing the sheet metal bracket to the overlay
panel.
⑤ Separate the inside gasket of the door and fasten it by inserting
the four screws into the four holes at the corners.
⑥ Fix the supplied door anchor bracket at the lower ends of the door
and decorative door.
⑦ Affix the completed door on the upper and lower hinge and fasten
the anchor screws of the lower hinge.
⑧ Check the operation and door swing.
②
③
⑥
④
⑦
14
⑤
Advertisement
Table of Contents
