Connecting The Speakers; Connecting To A Tv - Toshiba SD-43HT Owner's Manual

Connecting the Speakers

Turn off the Power first and set the volume knob to low initially before connecting.
Right front speaker
Left front speaker
Center speaker
Rear speaker
Rear speaker
(Left Surround)
(Right Surround)
Subwoofer
•
Note Be sure to match the speaker cord to the appropriate terminal on the components: + to + and
– to –. If the cords are reversed, the sound will be distorted and will lack bass.
•
If you use front speakers with low maximum input rating, adjust the volume carefully to avoid
excessive output on the speakers.
•
Do not disassemble the front cover of supplied speaker.
Ideal Speaker Placement
Front Speakers
Set the front speakers so that their tweeters
(high-range) are aligned at about ear level and at a
horizontal angle of 45° to the prime listening position.
Center Speaker
Ideally the center speaker should be positioned with its
top surface flush with the front speakers. However,
you may place the speaker either on top or near the
bottom of your TV set.
9
•
Connect the speakers using the supplied speaker
cords by matching the colors of the terminals and
those of the cords.
•
To obtain the best possible surround sound, adjust
the speaker parameters (distance, level, etc.).
Rear Speakers
Set the rear speakers further back, parallel to the
walls, at 60 to 90 centimeters (2 to 3 feet) above prime
listening position ear level.
If the space behind the listening position is insufficient
(i.e., too close to the wall), place the rear speakers
facing each other on either side.
Subwoofer Speaker
Place the subwoofer at any convenient location
within the vicinity of the listening position.

Connecting to a TV

Please turn off the Power of your TV, DVD receiver and other equipment before doing
any connections. Set the volume to low initially.
Depending on your TV and other equipment you wish to connect, there are various ways you could connect the player.
Use one of the connections described below.
Video connection (Good)
• Connect the VIDEO OUT jack on the DVD Receiver to the video in jack on the TV using
the video cable supplied (V).
S-Video connection (Better)
•
Connect the S-VIDEO OUT jack on the DVD Receiver to the S-Video in jack on the TV
using the optional S-Video cable (S).
Component Video (Color Stream®) connection (Best)
• Connect the COMPONENT VIDEO OUT jacks on the DVD Receiver to the corresponding
in jacks on the TV using an optional Y Pb Pr cable (C).
Note •
When the Progressive scan mode is selected, the VIDEO and S-VIDEO outputs do not feed
any signals. See page 16 to select Progressive Scan.
•
The signal of S-VIDEO OUT jack will output only when the function mode is selected to
CD/DVD.
Rear of TV
10