Connecting The Speakers; Connecting The Fm And Am(Mw/Lw) Antennas - Toshiba SD-43HK Owner's Manual

Toshiba home cinema system sd-43hk owner's manual
Hide thumbs Also See for SD-43HK:
Table of Contents

Advertisement

Connecting the Speakers

Turn off the Power first and set the volume knob to low initially before connecting.
Right front speaker Left front speaker
Center speaker
Rear speaker
Rear speaker
(Left Surround)
(Right Surround)
Subwoofer
Note
Be sure to match the speaker cord to the appropriate terminal on the components: + to + and
– to –. If the cords are reversed, the sound will be distorted and will lack bass.
If you use front speakers with low maximum input rating, adjust the volume carefully to avoid
excessive output on the speakers.
Do not disassemble the front cover of supplied speaker.
Ideal Speaker Placement
Front Speakers
Set the front speakers so that their tweeters
(high-range) are aligned at about ear level and at a
horizontal angle of 45° to the prime listening position.
Center Speaker
Ideally the center speaker should be positioned with
its top surface flush with the front speakers. However,
you may place the speaker either on top or near the
bottom of your TV set.
9
Connect the speakers using the supplied speaker
cords by matching the colors of the terminals and
those of the cords.
To obtain the best possible surround sound, adjust
the speaker parameters (distance, level, etc.).
Y
Rear Speakers
Set the rear speakers further back, parallel to the
walls, at 60 to 90 centimeters (2 to 3 feet) above
prime listening position ear level.
If the space behind the listening position is insufficient
(i.e., too close to the wall), place the rear speakers
facing each other on either side.
Subwoofer Speaker
Place the subwoofer at any convenient location
within the vicinity of the listening position.
Connecting the FM and AM
If FM reception is poor,
connect an outdoor FM antenna
(not supplied).
FM Antenna (supplied)
Cooling fan (See "About Cooling Fan" below.)
FM antenna connection
1. Connect the FM antenna supplied to the FM
75 COAXIAL terminal as temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75 coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
(About the cooling fan)
A cooling fan is mounted on the rear panel of the center unit to
prevent abnormal temperature inside the center unit, thus assuring
normal operation. The cooling fan automatically starts rotating to
supply external cool air to the inside of the center unit when the
internal temperature exceeds the specified limit.
Antennas
( MW )
1
2
3
If AM reception is
poor, connect an
outdoor AM
antenna(not
supplied).
AM Loop Antenna
ANTENNA
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.
Y
AM
antenna connection
(MW)
1. Connect the AM loop antenna supplied
to the AM and
terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM ter-
minal. (Keep the AM loop antenna con-
nected).
For safety, observe the following carefully.
• Make sure there is good ventilation around the center unit. Poor
ventilation could overheat and cause damage.
• DO NOT block the cooling fan and the ventilation openings or
holes. (If they are blocked by a newspaper or cloth, etc., the heat
may not be able to escape.)
(supplied)
10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents