Alto HPA6 Owner's Manual page 6

Rear Panel
Rated Power
Consumption 40W
FUSE:
210-240V: T315mAL 250VAC
95-120V: 500mA 250VAC
REPLACE FUSE WITH
CORRECT TYPE ONLY
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
A101
DESIGNED IN ITALY
MADE IN CHINA
12
12 AC Inlet and Fuse Holder
This connector is used to connect the supplied power cord. Please check the Voltage
accepted by the unit and the Voltage available from your AC sockets before connecting
the unit to the Mains.
If the fuse blows, replaced with a fuse of the correct type only.
13 MAIN INPUT LEFT & RIGHT
These connectors are used to input the stereo signal. Y ou can input the main signal
via the balanced 1/4" TRS phone jack or XLR connector .
14 Main Output Connectors
These connectors are used to output the stereo signal via the balanced 1/4" TRS
phone jack or XLR connector . Y ou can also use these connectors to link as many
additional HPA6 as you wish if you need to use many headphones channels.
15 HEADPHONE OUT (1 to 12)
These are 12 additional outputs for headphone (two for every channel) wired in
parallel with the output available on the front channel.
3. CONTROL ELEMENTS 3. CONTROL ELEMENTS
TIP:
L- CHANNEL
RING:
R- CHANNEL
MIN. LOAD
100OHMS
HEADPHONE OUT 6 HEADPHONE OUT 5 HEADPHONE OUT 4 HEADPHONE OUT 3 HEADPHONE OUT 2 HEADPHONE OUT 1
15
TIP/PIN 2 TIP/PIN 2 TIP/PIN 2
RING/PIN 3 RING/PIN 3 RING/PIN 3
SLEEVE/PIN 1 SLEEVE/PIN 1 SLEEVE/PIN 1
MAIN OUTPUT RIGHT MAIN OUTPUT LEFT
14
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
MAIN INPUT RIGHT MAIN INPUT LEFT
13
4