Table of Contents
Advertisement
[WIRING PRECAUTIONS]
Be sure to fix communication cables and power cables to the module by
ducts or clamps.
Failure to do so may cause damage of the module or the cables due to
accidental pull or unintentional shifting of the cables, or malfunctions due to
poor contact of the cable.
Connect the connectors to the module securely.
Tighten the terminal screws within the specified torque range.
Loose tightening may result in a fall, short circuits or malfunctions.
Overtightening may cause damage to the screw and/or the module, resulting
in a fall, short circuits or malfunctions.
Do not hold the communication cable by hand when pulling it out from the
module.
Be sure to hold the connector by hand, when removing the cable with a
connector from the module.
Failure to do so may cause malfunctions or damage to the module or cable.
Be careful not to let foreign matter such as dust or wire chips get inside the
module. This may cause a fire, failure or malfunctions.
A protection label is attached to cover the upper part of a module to prevent
the entry of foreign matter. Do not remove the label during wiring. However,
be sure to remove it for heat dissipation during system operation.
[TRANSPORTATION PRECAUTIONS]
When transporting lithium batteries, make sure to treat them based on the
transport regulations. (Refer to Chapter 8 for details of the controlled
models.)
CAUTION
CAUTION
A-3
Advertisement
Table of Contents
