Table of Contents
Advertisement
(c) Logging monitor setting (bit 4)
Whether the latest file update time is displayed or not in the file
specification field of the logging monitor is set in this setting.
0: Not display the latest file update time.
1: Displays the latest file update time.
(3) Response monitoring time setting (switch 3 (lower byte))
This is the setting for timeout time (second) from when a module sends a
request to the CPU of the accessed device until the CPU responds to it.
Response timeout error will occur if the CPU of the accessed device does
not respond to the request after the set time has passed.
Setting range: 15 to 255 (second)
Response monitoring time will be automatically default value (15 seconds)
if it is not set or set to any of 0 to 14.
b15
to
(Upper byte) *
Specify 0. *
* The upper byte is basically ignored. However, a switch setting
error (0180h) will occur during hardware test if the upper byte
is other than 0.
b8 b7
to
(lower byte)
10
(default value: 15 seconds)
b0
Swich 3
Response monitoring time setting
15 to 255 (seconds)
Response monitoring time will be
automatically default value (15
seconds) if it is not set or set to
any of 0 to 14.
Advertisement
Table of Contents
