Pre- Fix Ip Number; Pabx User Mode; Welcome Note; Memory Full - Linkcom Link 721 User Manual

Pre- fix IP Number

If you always need to dial the pre-fix operator code, you can enter the pre-fix IP number first, then all
the dialed out number will be automatically added to the prefix number.
Set up pre-fix IP number
Press *477* buttons + pre-fix IP number + # button.
Once you set the prefix number, then each time you pick up handset or press to dial out one
number, the unit will firstly dial out the pre-fix number.
Delete the IP number
Press *477* + # buttons, the Pre-fix IP number will be deleted.
Temporary disable IP function.
1. Press ** buttons.
2. Dial the phone number without the pre-fix IP number first temporarily.

PABX user mode

If you are using the phone with a PABX, you can dial out the phone memories without dialing the
PABX prefix each time.
Procedures to set the PABX prefix ON:
In idle state, press # + 7229 buttons + PABX prefix 'any one digit' & then press "OK" button.
Remarks: 7=P, 2=A, 2=B, 9=X. The user will easily remember the PABX code (7229)
Example: (suppose 0 is the PABX prefix access)
# + 7229 + 0 + OK
After this setting, all phone memories will be dialing out with 0 first.
Disable the PABX user mode.
In idle state, press # + 7229 + OK buttons.

Welcome note

The unit provides the personal facility that shows your personal information, such as your name or
your company name, on LCD in standby mode. To introduce the welcome note, you can follow below
procedures.
[1]In standby mode, press *93 52 663# buttons, then the LCD will show "-".
[2]Enter your personal information (Maximum 14 characters) & Press "OK" key for confirmation, then
the LCD will show the information.
NOTE: 9=W, 3=E, 5=L, 2=C, 6=O, 6=M,3=E(welcome), It will be easy for the user to remember the
Welcome note code.

Memory full

There are 50 phonebook memories.
The LCD will show memory full when all memories have been occupied in the phonebook. The user
should delete some messages which are stored in the phonebook.
8