1. Manuals
  2. Brands
  3. Linkcom Manuals
  4. Telephone
  5. Link 904
  6. User manual

Linkcom Link 904 User Manual

Linkcom link 904 telephone user guide
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
LINK 904
User guide for
Link 904

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Link 904 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Linkcom Link 904

Summary of Contents for Linkcom Link 904

  • Page 1 LINK 904 User guide for Link 904...

  • Page 2: Table Of Contents

    3.4 SPEED DIALLING..................7 3.5 RECALL ....................... 7 3.6 VOLUME CONTROL .................. 7 3.7 MUTE ......................7 4. APPROVED USE..................8 5. CE APPROVED ..................8 6. THE NUMBER OF TELEPHONES THAT MAY BE CONNECTED ..8 Link 904 – User Manual...
  • Page 3 REDIAL/ PAUSE BUTTON MESSAGE WAITING INDICATION In the manual, some parameters have to be set up by moving some switches. These switches are located into the cable connection compartment at the back of the phone. Link 904 – User Manual...

  • Page 4: Installation

    2. TELEPHONE SETUP 2.1 MICROPHONE SENSITIVITY SETTING The Link 904 is design for use in a wide variety of locations. To cater for these different installation conditions it is possible to adjust the microphone sensitivity of the unit using the following procedure.

  • Page 5: Message Waiting Setup

    The switch should be set to OFF if no message waiting is required on the installation. 2.3 DIAL MODE SETUP To Link 904 can be set to either Tone or Pulse dialling as follows: PULSE - Press [SPEAKER ON][STORE][3][0][STORE] TONE - Press [SPEAKER ON][STORE][3][1][STORE] STORE button is located under the memory label.

  • Page 6: Auto Disconnect Setup

    To activate the facility switch SW9 to either '60s' (60 seconds) or '120s' (120 seconds). 2.6 AUTO ANSWER The link 904 can be set to auto answer a telephone call after 5 rings. To select this option set switch SW5 to 'ON'. 2.7 MEMORY PROGRAMMING...

  • Page 7: Operation

    To resume the call, press the [SPEAKER ON] button and resume conversation. Alternatively, pick up another telephone connected in parallel with the Link 904 and the hold indicator will be turned Off. Link 904 – User Manual...

  • Page 8: Approved Use

    (RENs) of all the equipment you wish to connect. If this number exceeds four, your telephones may not ring. Your Link 904 telephone has an REN of one (1). telephones have an REN of one unless otherwise marked.

Table of Contents