Stopping; Height Of Cut; Before Mowing - Hayter Envoy Code 100C Owner's Handbook Manual

OPERATING THE MOWER

Stopping

Release the bail arm to stop the motor.
WARNING: AVOID ACCIDENTS - The cutterblade may contin-
ue to rotate after the mower is switched off

Height of Cut

Move the height of cut lever sideways to disengage it from the locking
notch, then push forwards to lower or pull backwards to raise the height
of cut. Release the lever in the required position and ensure that it locks
firmly into one of the seven notch settings.
Always select a height of cut to suit operating conditions. Prevent
motor overloading and blockages by avoiding low cuts in long grass
conditions. Be prepared to make two cuts when the grass is long.
305113
CS284

Before Mowing

To prevent accidents thoroughly inspect the area and remove all
objects which when contacted by the mower cutterblade could
become dangerous projectiles. Inspect the area for hidden obstruc-
tions which when contacted by the cutterblade could risk health
and safety. Remember the location of these obstructions and
ensure that you mow around them.
1.12