HP 1910 Series Datasheet page 11

HP 1910 Switch Series
Specifications (continued)
HP 1910-8G-PoE+ (65W) Switch (JG349A)
Ports
8 RJ-45 auto-negotiating 10/100/1000 PoE+ ports (IEEE
802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX,
IEEE 802.3ab Type 1000BASE-T, IEEE 802.3af PoE, IEEE
802.3at)
1 SFP 1000 Mbps port
1 RJ-45 console port to access limited CLI port
Supports a maximum of 8 autosensing 10/100/1000
ports plus 1 1000BASE-X SFP ports, or a combination
Physical characteristics
10.24(w) x 11.81(d) x 1.72(h) in (26 x 30 x 4.36 cm) (1U
height)
Weight
6.61 lb (3 kg)
Memory and processor
ARM @ 333 MHz, 128 MB flash, 128 MB RAM; packet
buffer size: 512 KB
Mounting
Mounts in an EIA standard 19-inch telco rack or
equipment cabinet (hardware included)
Performance
100 Mb Latency
< 5 µs
1000 Mb Latency
< 5 µs
Throughput
up to 13.4 Mpps (64-byte packets)
Routing/Switching capacity
18 Gb/s
Routing table size
32 entries (IPv4), 32 entries (IPv6)
MAC address table size
8192 entries
Environment
Operating temperature
32°F to 113°F (0°C to 45°C)
Operating relative humidity
10% to 90%, noncondensing
Nonoperating/Storage temperature
-40°F to 158°F (-40°C to 70°C)
Nonoperating/Storage relative humidity 10% to 95%, noncondensing
Electrical characteristics
Frequency
50/60 Hz
Voltage 100-240 VAC
Maximum power rating
93 W
PoE power
65 W
Notes
Maximum power rating and maximum heat dissipation
are the worst-case theoretical maximum numbers
provided for planning the infrastructure with fully
loaded PoE (if equipped), 100% traffic, all ports plugged
in, and all modules populated.
PoE power is the power supplied by the internal power
supply. It is dependent on the type and quantity of
power supplies.
Safety
UL 60950; IEC 60950-1; EN 60950-1; CAN/CSA-C22.2 No.
60950-1-03
Emissions
FCC part 15 Class A; VCCI Class A; EN 55022 Class A;
CISPR 22 Class A; EN 55024; EN 61000-3-2 2000,
61000-3-3; ICES-003 Class A
Management
IMC - Intelligent Management Center; limited
command-line interface; Web browser; SNMP Manager;
IEEE 802.3 Ethernet MIB
Notes
SFP port and copper ports work simultaneously,
independent of each other, to provide a total of 9 Gigabit
Ethernet-capable ports.
HP 1910-8G-PoE+ (180W) Switch (JG350A)
8 RJ-45 auto-negotiating 10/100/1000 PoE+ ports (IEEE
802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX,
IEEE 802.3ab Type 1000BASE-T, IEEE 802.3af PoE, IEEE
802.3at)
1 SFP 1000 Mbps port
1 RJ-45 console port to access limited CLI port
Supports a maximum of 8 autosensing 10/100/1000
ports plus 1 1000BASE-X SFP ports, or a combination
10.24(w) x 11.81(d) x 1.72(h) in (26 x 30 x 4.36 cm) (1U
height)
6.61 lb (3 kg)
ARM @ 333 MHz, 128 MB flash, 128 MB RAM; packet
buffer size: 512 KB
Mounts in an EIA standard 19-inch telco rack or
equipment cabinet (hardware included)
< 5 µs
< 5 µs
up to 13.4 Mpps (64-byte packets)
18 Gb/s
32 entries (IPv4), 32 entries (IPv6)
8192 entries
32°F to 113°F (0°C to 45°C)
10% to 90%, noncondensing
-40°F to 158°F (-40°C to 70°C)
10% to 95%, noncondensing
50/60 Hz
100-240 VAC
228 W
180 W
Maximum power rating and maximum heat dissipation
are the worst-case theoretical maximum numbers
provided for planning the infrastructure with fully
loaded PoE (if equipped), 100% traffic, all ports plugged
in, and all modules populated.
PoE power is the power supplied by the internal power
supply. It is dependent on the type and quantity of
power supplies.
UL 60950; IEC 60950-1; EN 60950-1; CAN/CSA-C22.2 No.
60950-1-03
FCC part 15 Class A; VCCI Class A; EN 55022 Class A;
CISPR 22 Class A; EN 55024; EN 61000-3-2 2000,
61000-3-3; ICES-003 Class A
IMC - Intelligent Management Center; limited
command-line interface; Web browser; SNMP Manager;
IEEE 802.3 Ethernet MIB
SFP port and copper ports work simultaneously,
independent of each other, to provide a total of 9 Gigabit
Ethernet-capable ports.
HP 1910-24 Switch (JG538A)
24 RJ-45 autosensing 10/100 ports (IEEE 802.3 Type
10BASE-T, IEEE 802.3u Type 100BASE-TX); Duplex: half
or full
2 SFP dual-personality 1000 Mbps ports (IEEE 802.3ab
Type 1000BASE-T)
1 RJ-45 console port to access limited CLI port
Supports a maximum of 24 autosensing 10/100 ports
plus 2 1000BASE-X SFP ports, with optional module
17.32(w) x 6.81(d) x 1.73(h) in (44 x 17.3 x 4.4 cm) (1U
height)
4.85 lb (2.2 kg)
MIPS @ 500 MHz, 32 MB flash, 128 MB RAM; packet
buffer size: 512 KB
Mounts in an EIA standard 19-inch telco rack or
equipment cabinet (hardware included)
< 5 µs
< 5 µs
up to 6.6 Mpps (64-byte packets)
8.8 Gb/s
32 entries (IPv4), 32 entries (IPv6)
8192 entries
32°F to 104°F (0°C to 40°C)
10% to 90%, noncondensing
-40°F to 158°F (-40°C to 70°C)
10% to 95%, noncondensing
50/60 Hz
100-240 VAC
12 W
Maximum power rating and maximum heat dissipation
are the worst-case theoretical maximum numbers
provided for planning the infrastructure with fully
loaded PoE (if equipped), 100% traffic, all ports plugged
in, and all modules populated.
IEC 60950-1; EN 60950-1; UL 60950-1 2nd Edition; CSA
C22.2 No. 60950-1-07 2nd Edition
FCC part 15 Class A; VCCI Class A; EN 55022 Class A;
CISPR 22 Class A; EN 55024; EN 61000-3-2 2000,
61000-3-3; ICES-003 Class A
IMC - Intelligent Management Center; limited
command-line interface; Web browser; SNMP Manager;
IEEE 802.3 Ethernet MIB
The HP 1910-24G Switch (JE006A) was formerly sold as
the 3Com Baseline Plus 2928 (3CRBSG2893) and may
ship with this product labeling.
SFP ports and copper ports can work simultaneously,
independent of each other, to provide a total of 28
Gigabit Ethernet-capable ports.
11