Cycle Settings - Kenmore 417.8112 Series Use & Care Manual

Operating Instructions

Cycle Settings

For best results
Follow the fabric care label instructions
on items to be dried.
Appropriate drying Temperature, Dryness Level and Op-
tions will automatically be displayed for each cycle. The
settings can be changed before the cycle is started. To
protect your fabrics, not all settings and options are avail-
able with every cycle. The indicator will not light if the
setting is not available with that cycle.
Modifi cations for each cycle will be remembered and
recalled each time that cycle is selected in the future. If
changes are attempted after the cycle starts, the lights will
blink, the signal will beep and "
NOTE
To change settings after the cycle starts, press PAUSE,
adjust the setting and press START to resume the cycle.
DRYING TEMPERATURE
To change the preset temperature, press the Temp button
to scroll to the desired setting.
To protect your fabrics, not all temperatures are available
with every cycle.
The temperature selected for the cycle will be remembered
and recalled each time that cycle is selected in the future.
Max
Recommended for durable fabrics and towels.
High
Recommended for most cotton fabrics.
Medium
Recommended for wrinkle free, easy care, lightweight
fabrics and bulky loads.
Low
Recommended for delicate fabrics.
Air Fluff
This setting (no heat) should only be used with a Timed Dry
cycle to dry items containing feathers, down, foam rubber,
plastics or rubber-like materials; to refresh clothing, stuff ed
animal, pillows or blankets; and to dust draperies.
Err
" will be displayed.
To return to factory set-
tings, press these two
buttons at the same time
and hold until the signal
sounds.
DRY LEVEL (Auto Dry)
To change the preset level, press the Dry Level button to
scroll to the degree of dryness desired.
To protect your fabrics, not all dryness levels are available
with every cycle. If a Dry Level is not appropriate for the
cycle, it cannot be selected.
The Dry Level selected for the cycle will be remembered
and recalled each time that cycle is selected in the future.
Select the Normal dry level for most Auto Dry cycles.
Occasionally a load may seem too damp or over-dried
at the end of the cycle. To increase drying time for similar
loads in the future, select a higher setting. For loads requir-
ing less drying time, select a lower setting.
Select Damp for items you wish to partially dry before
hanging or ironing.
Cycle Options
To select an option, press Options until the indicator for the
desired option fl ashes, then press Select. If an option is not
available for a cycle, the indicator will not light. Follow the
same steps to delete an option.
The options selected for the cycle will be remembered and
recalled each time that cycle is selected in the future. To re-
turn to factory settings, press the START/PAUSE and Select
buttons at the same time and hold until the signal sounds.
NOTE
To change the options after the cycle starts, press PAUSE,
adjust the options and press START to resume the cycle.
Chime
A signal will sound at the end of the cycle (and periodi-
cally during Wrinkle Guard) if this option is selected. The
signal has an adjustable volume level or can be turned
off .
Wrinkle Guard
Select Wrinkle Guard if the dried load might not be
removed promptly at the end of the cycle. The dry
load will continue tumbling without heat to help reduce
wrinkling. When Chime is selected, a beep will be heard
periodically. The load may be removed any time during
Wrinkle Guard.
8