Honda 2008 PILOT Installation Instructions Manual page 5

audio unit.
15. Connect the two vehicle connectors and the
BUS CABLE
14-PIN
CONNECTOR
BUS CABLE
antenna connector to the audio unit. Insert the
audio unit into the audio panel opening and
secure it with the four screws that you removed in
step 6.
16. At the heater control unit opening, attach two EPT
VEHICLE 14-PIN
CONNECTOR
(2WD vehicle only.)
AUDIO UNIT
AUDIO
BRACKET
SCREWS
(Reuse.)
©
2007 American Honda Motor Co., Inc. - All Rights Reserved.
AUDIO UNIT
5426250Y
VEHICLE 20-PIN
CONNECTOR
ANTENNA
CONNECTOR
AUDIO
BRACKET
5426260Y
All 37152 (0706)
sealers to the bus cable at the location shown.
17. Secure the bus cable to the vehicle harness using
BUS
CABLE
WIRE TIE
EPT
SEALER
AIR
DUCT
HEATER
CONTROL
UNIT
OPENING
VEHICLE 30-PIN
CONNECTOR
one wire tie.
18. Connect the bus cable 14-pin connector to the
VEHICLE
HARNESS
VEHICLE 20-PIN
CONNECTOR
BUS
CABLE
5426131Y
5 of 6