Honda 2008 PILOT Installation Instructions Manual page 4

vehicle brackets. Pull the heater control unit and
pocket out toward you, and unplug the vehicle
connectors.
11. Remove the left and right vehicle brackets (six
VEHICLE 20-PIN
CONNECTOR
HEATER
CONTROL UNIT
LEFT
VEHICLE
BRACKET
SCREWS
self-tapping screws), and separate the heater
control unit from pocket. Set the pocket aside, it
will not be reused.
12. Install the DIN bezel to the player. Set the heater
SELF-
TAPPING
SCREWS
LEFT VEHICLE
(Reuse.)
BRACKET
(not reused)
SELF-
TAPPING
SCREWS
POCKET
4 of 6
VEHICLE 30-PIN
CONNECTOR
POCKET
RIGHT
VEHICLE
BRACKET
HEATER
SELF-
CONTROL UNIT
TAPPING
SCREWS
(Reuse.)
SELF-
RIGHT
TAPPING
VEHICLE
SCREWS
BRACKET
(not reused)
control unit on the player, and attach the left and
right player brackets to the player and the heater
control unit using the two self-tapping screws
removed in step 11 and four 5 x 8 mm washer-
screws included with the player.
Installing the Player
SELF-TAPPING SCREW
(Removed in step 11.)
LEFT PLAYER
BRACKET
5 x 8 mm
WASHER
SCREW
(Included with
the player.)
13. Route the bus cable from the audio panel opening
to the heater control unit opening. Using one wire
tie, secure the bus cable to the vehicle harness.
14. Connect the bus cable 14-pin connector to the
VEHICLE
HARNESS
30 mm
All 37152 (0706)
HEATER
CONTROL
UNIT
DIN BEZEL
PLAYER
RIGHT
PLAYER
BRACKET
BUS CABLE
14-PIN
CONNECTOR
WIRE TIE
TO AUDIO UNIT
HEATER
CONTROL
UNIT
OPENING
5426240Y
©
2007 American Honda Motor Co., Inc. - All Rights Reserved.
SELF-
TAPPING
SCREW
(Removed
in step 11.)
5 x 8 mm
WASHER
SCREW
(Included
with the
player.)
5715030Y
AUDIO
PANEL
OPENING
BUS
CABLE