Machine's Safety Equipment - Husqvarna WB48S Operator's Manual

and lower to an appropriate height. If the grass is
really long, drive slowly and mow twice if necessary.
• Never run with the machine when it is running. You
should always walk with the lawn mower.
• Do not mow the lawn while walking backwards.
Cutting height
Shut down the engine before changing the cutting height.
The cutting height adjustment is spring assisted. The
cutting height can be adjusted in 6 different steps.
Do not set the cutting height too low as there is a risk that
the cutters might hit ground with unevenness.
• To raise the cutting height move the lever to the left
and then forward.
• To lower the cutting height move the lever to the left
and then backward.
8 – English
SAFETY INSTRUCTIONS

Machine's safety equipment

This section describes the machine's safety equipment,
its purpose, and how checks and maintenance should be
carried out to ensure that it operates correctly. See the
"What is what?" section to locate where this equipment is
positioned on your machine.
WARNING! Never use a machine with
!
faulty safety equipment. The machine's
safety equipment must be checked and
maintained as described in this section.
If your machine fails any of these checks
contact your service agent to get it
repaired.
WARNING! Never use a machine that has
!
faulty safety equipment! Carry out the
inspection, maintenance and service
routines listed in this section.
Cutting cover and protective cover
The cutting cover is designed to reduce vibration and to
reduce the risk of cuts. Make sure the cutting cover is not
damaged and that there are no visible defects such as
cracks.
The protective cover is designed to reduce the risk of
crush injuries and to catch a broken drive belt. Check that
the protective cover is undamaged and that it is properly
secured.
Engine brake handle
The engine brake is designed to stop the engine. When
the grip on the engine brake handle is released the engine
should stop.
Check the engine brake as follows:
Apply full throttle and then release the brake handle. The
engine should stop and the drive should disengage.
The engine brake should always be adjusted so that the
engine stops within 3 seconds.