Display Assembly - HP Mini 210 Maintenance And Service Manual

Reverse this procedure to install the TouchPad button board.

Display assembly

NOTE: For a complete list of display assemblies, refer to
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service door (see
6. Disconnect the WLAN antenna cables from the WLAN module (see
7. Disconnect the WWAN antenna cables from the WWAN module (see
on page
8. Remove the keyboard (see
9. Remove the top cover (see
Remove the display assembly:
1. Close the computer.
2. Position the computer upside down, with the front toward you.
3. Remove the back corner rubber feet (1).
4. Remove the two Phillips M2.0x5.0 screws (2), one beneath each rubber foot.
5. Remove the plastic rear corner covers (3).
NOTE:
Battery on page
Service door on page
47).
Keyboard on page
Top cover on page
The rear corner covers are included in the Plastics Kit, spare part number 652308-001.
Display components on page
44).
45).
53).
56).
Component replacement procedures
25.
WLAN module on page
WWAN module
46).
61