Direct Tv Recording - Sharp VC-FH30FPM Manual

BASIC OPERATION

DIRECT TV RECORDING

This feature can only be used with nexTView, Smart Link, Easy
Link and Megalogic compatible tv's.
By pressing the DIRECT TV REC
signal currently being displayed on the TV regardless of the signal source.
This feature can be started when the VCR is in STANDBY or OPERATE mode.
• If appears on the VCR display, press
• Ensure a video tape is inserted in the VCR.
1.
To start the recording, press
2.
To pause during recording, press
3.
To continue recording, press
4.
To stop recording, press
NOTES:
• A fully wired scart must be used for DIRECT TV RECORD operation.
• If DIRECT TV RECORD could not start, the TV should indicate the reason why.
(Refer to the TV operation manual).
TIMER RECORDING
It is possible to program the VCR using three different methods :-
1.
NexTView
2.
Showview
3.
Manually (DELAYED RECORDING)
HOW TO USE NexTView TO MAKE A RECORDING
• If appears on the VCR display, press
• Check that the clock is displaying the correct time.
Some broadcasts transmit an Electronic Program Guide (EPG) in which case, using the TV con-
trols, the program you wish to record can be selected and used to program the VCR automat-
ically. This feature is compatible with NexTView TV's. Refer to your TV operation manual for
further information. After transfer of the timer information to the VCR, the timer menu will be dis-
played for approximately 5 seconds, after which press
VCR in STANDBY mode.
NOTES:
• The timer menu will not be displayed if this procedure is carried out while the VCR is in
STANDBY mode.
• If flashes a video tape has not been inserted into the VCR.
• During recording, press STOP (
ings to be made, the VCR will return to TIMER STANDBY.
button on the remote control, the VCR will record the
TIMER ON/OFF
DIRECT TV REC
PAUSE (
REC
( ) .
STOP ( ).
TIMER ON/OFF
will be shown on the display.
) to cancel the recording. If there are further record-
12
before starting.
.
) .
before starting.
TIMER ON/OFF once to place the