Windows Nt Diagnostics - Farallon SkyLINE 11Mb User Manual

32 Chapter 3
W
If you have trouble when using your card with Windows NT, you can
use Windows NT Diagnostics to check the following items.
1. Click Start in the Windows taskbar.
2. Select Programs > Administrative Tools.
3. Click Windows NT Diagnostics.
4. Click the Resources tab.
5. Click IRQ to display IRQs in use by other devices.
6. The default IRQ for the PCMCIA card is 09. If this is in use by
7. Click on the Memory tab to open the Memory box.
8. Look for an entry that includes CW10.
9. Right-click on Network Neighborhood icon on the desktop. Left-
10. Click on the Adapters tab and then on the Properties button.
11. In the Adapter Setup dialog box, change the Memory Base from
12. Click on the Protocols tab and verify that the NetBEUI and TCP/IP
13. Click on the Identification tab to set up your Workgroup. Give your
14. Click OK to register any changes.
15. Click Close in the Network dialog box to complete setup.
NT D
INDOWS IAGNOSTICS
another device, you must select another IRQ for the PCMCIA card.
If it is present, the card is properly installed.
If CW10 is not present, continue below.
click on Properties.
C8000 to DF000. Click OK. Restart if prompted.
protocols are active. If not, click on the Add button to add each of
them.
computer a unique name and a workgroup name. All computers
that are intended to share file or printers must use the same
workgroup name.