Table of Contents
Advertisement
C
ONFIGURING THE
Use the configuration utility to modify the card's configuration after
software installation. All devices on the network, including any access
points, must be set to the same configuration settings.
1. Open the Configuration Utility by double clicking on the SkyLINE
monitor icon located on the Windows taskbar. The monitor icon is
green if the PC has link, and red if it does not have link.
2.
The Station Configuration panel appears.
Make any desired changes to the Configuration panel, including:
Mode: select Infrastructure or Ad Hoc mode.
Ethernet Conversion: the default is RFC1042, which is the
equivalent of Translation mode used in the Macintosh Wireless
Control Panel. You can also choose Encapsulation mode.
Tx Rate: the default setting is Fully Automatic, allowing the driver
to adjust the data transfer rate automatically.
WEP: if you do not want to use WEP, leave Disabled selected.
Select Mandatory from the WEP pop-up menu to enable WEP if
you want to use Wireless Encryption on your network. WEP can be
used when in Ad Hoc or Infrastructure mode.
S
LINE C
KY
ARD FOR
Installation
W
INDOWS
21
Advertisement
Table of Contents
Troubleshooting
