Do you have a question about the EasyTouch 6310 and is the answer not in the manual?
Questions and answers
Sheryl Lumpkins
March 19, 2025
no water will come out of the faucet
1 comments:
Mr. Anderson
March 19, 2025
There could be several reasons why no water is coming out of the American Standard EasyTouch 6310 faucet:
1. Water Supply is Turned Off – Ensure that the hot and cold water supplies are turned on. The instructions specify turning off the water supply before installation, so it may not have been turned back on.
2. Hoses Not Connected Properly – Verify that the flexible supply hoses are correctly connected to the wall supply. The hot supply (red stripe) should be connected to the left, and the cold supply (blue stripe) to the right.
3. Clogged or Blocked Lines – The manual instructs flushing the water lines by operating the handle up and down in both hot and cold positions. If this was not done, debris might be blocking water flow.
4. Hand Spray Connection Issue – If the hand spray is not properly connected to the hose, water may not flow. Ensure the washer is in place and the connection is secure.
5. Locknut or Screws Too Tight – If the locknut and screws were overtightened during installation, it may be restricting water flow. Loosen slightly and check if water flows.
Checking these potential issues should help restore water flow.
This answer is automatically generated
Patricia
April 15, 2025
DOES THE KITCHEN FAUCET SERIES 6310 m968474 rEV.1.2 COME IN BISQUE
Related Manuals for American Standard EasyTouch 6310
Need help?
Do you have a question about the EasyTouch 6310 and is the answer not in the manual?
Questions and answers
no water will come out of the faucet
There could be several reasons why no water is coming out of the American Standard EasyTouch 6310 faucet:
1. Water Supply is Turned Off – Ensure that the hot and cold water supplies are turned on. The instructions specify turning off the water supply before installation, so it may not have been turned back on.
2. Hoses Not Connected Properly – Verify that the flexible supply hoses are correctly connected to the wall supply. The hot supply (red stripe) should be connected to the left, and the cold supply (blue stripe) to the right.
3. Clogged or Blocked Lines – The manual instructs flushing the water lines by operating the handle up and down in both hot and cold positions. If this was not done, debris might be blocking water flow.
4. Hand Spray Connection Issue – If the hand spray is not properly connected to the hose, water may not flow. Ensure the washer is in place and the connection is secure.
5. Locknut or Screws Too Tight – If the locknut and screws were overtightened during installation, it may be restricting water flow. Loosen slightly and check if water flows.
Checking these potential issues should help restore water flow.
This answer is automatically generated
DOES THE KITCHEN FAUCET SERIES 6310 m968474 rEV.1.2 COME IN BISQUE