Adjusting The Cut-Off Frequency; Listening To Each Program Source In Its Registered Equalizer Curve - Sony XDP-210EQ Operating Instructions Manual

Adjusting the cut-off
frequency
— Crossover Network (CNW)
— Sound Tuning Mode
To match the characteristics of the connected
speakers or subwoofer(s), you can cut the
unwanted high, middle and low frequency
signals entering the speakers or subwoofer(s).
By setting the cut-off frequency (see the
diagram below), the speakers will output only
the most suitable frequency signals so that you
can get a clearer sound image.
Low Pass Filter (Subwoofer)
Cut-off frequency
50 62 78 99 125 157
High Pass Filter (Front, Rear)
Cut-off frequency
78 99 125 157 198
1
Press (SOUND) for two seconds.
2
Press (SOUND) repeatedly until "CNW"
appears.
CNW Cut off
SUB125Hz
SUR EQ
3
Adjust the cut-off frequency
1 Press (1) (N) or (4) (n) to select the
line out.
SUB (Subwoofer) ˜ F (Front)
˜ R (Rear)
CNW Cut off
F Flat
SUR EQ
Actual total number:
2 Rotate/press (+) to select the desired
3 Repeat steps 1 and 2 to select the
4
Press (SOUND) for two seconds.
When the cut-off frequency setting is
complete, the display goes back to the
normal playback mode.
Tip
To adjust the subwoofer level, select "SUB" by pressing
(1) (N) or (3) (n) after step 3 above. Then rotate/press
(+) or (–) to adjust the level. When you finish adjusting
the subwoofer level, press (SOUND) for two seconds.
Frequency (Hz)
Listening to each program
source in its registered
equalizer curve
— Source Sound Memory
You can listen to the same source (CD, MD,
TAPE, FM, AM, TV and AUX) always in the
same equalizer curve and sound characteristics
(bass, treble and subwoofer level) even after
changing the program source or turning the
Frequency (Hz)
unit on and off again.
Note
"LSM" (Last Sound Memory) appears on the TV display
when you have selected an equalizer curve.
Sony XDP-210EQ (E) 3-856-153-12 (1)
cut-off frequency.
Subwoofer :
50 Hz n 62 Hz n 78 Hz n 99 Hz n 125 Hz
n 157 Hz
Front, Rear:
Flat n 78 Hz n 99 Hz n 125 Hz n 157 Hz
n 198 Hz
CNW Cut off
F 125Hz
SUR EQ
If you rotate/press (–), the cut-off
frequency appear in the reverse order.
cut-off frequency.
EN
7