Enter Cooling Program; Check Your Programming - American Standard ASYSTAT656 Operation Manual

Enter Cooling Program

CAUTION
!
If outside temperature is below 50°F, we
recommend that you remove the thermo-
stat from the wall before proceeding with
the following steps to program cooling
temperatures. A fresh 9V alkaline bat-
tery must be installed to perform off-wall
programming. Programming away from
the wall should prevent accidental com-
pressor operation. BE SURE SYSTEM
SWITCH IS SET TO OFF POSITION BE-
FORE REATTACHING THE THERMO-
STAT TO THE SUBBASE!
SYSTEM
1. Press until COOL is displayed.
SWITCH
2. Enter your cooling program by following the
same procedure you followed for entering your
heating program.

CHECK YOUR PROGRAMMING

Follow these steps to check your thermostat
programming one final time before beginning
thermostat operation.
1. Press SYSTEM until HEAT is displayed.
SWITCH
2. Press and hold
period times and temperatures in sequence
for weekday, then weekend MOR, DAY,
EVE, and NHT program periods.
RUN
3. Press .
PRGM
VIEW
to view the heating
PRGM
27