Epson EB-1776W User Manual page 36

Adjusting Projected Images
b
Adjust the zoom ring so that the yellow frame is bigger than the
screen frame as shown below. Position the black message box in
the center of the screen.
If the yellow frame is still within the screen frame even after
adjusting the zoom ring to its maximum size, try moving the
projector further away from the screen.
c
Press the [Screen Fit] button or the [
After the adjustment screen appears, the projected image is corrected
according to the aspect ratio
] button.
g of the image being input.
a
Once the adjustment screen appears, do not move the projector
or block the image. The projected image will not be corrected
properly.
d
After the correction is performed, the following message appears.
To exit the correction menu, press the [Esc] button on the remote
control or the control panel to clear the message.
To make fine adjustments after the initial adjustment, press the
[ ][ ][ ][ ] buttons on the control panel.
If no operation is performed, the message closes after about seven
seconds.
After performing Screen Fit, Keystone on the Configuration menu is
set to Quick Corner. After this, any correction of the projected
image using the [ ][
performed using the Quick Corner function.
"Correcting manually - Quick Corner -"
s
][ ][ ] buttons on the control panel is
p.39
36